SDI

[Anonymous]

Does anyone know if SDI default setting for Acad LT 2008 is 1 or 0

[Anonymous]

It's always off by default.

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--

[Anonymous]

It is not a bool it is an integer!
So off is not correct!

Valid values are 0,1,2

The default setting is 0 unless you have an app loaded that is not SDI aware
then the setting is 2.


Regards Gary.

[Anonymous]

Semantics, the meaning came through fine and the OP asked
about default setting, not "... what if an application needs
it...": all you posted is explained in Help, there was no
mystery for anyone.

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--

[Anonymous]

Fine Half right is O.K!

Regards Gary D'Arcy.

"Dean Saadallah" wrote in message
news:5569097@discussion.autodesk.com...
Semantics, the meaning came through fine and the OP asked
about default setting, not "... what if an application needs
it...": all you posted is explained in Help, there was no
mystery for anyone.

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--