AutoCAD LT General Discussion

AutoCAD LT General Discussion

Reply
*Bleckley, John
Message 1 of 3 (53 Views)

hatch scale

53 Views, 2 Replies
01-18-2000 12:44 PM
I am trying to hatch in a previously created drawing. It was created and
includes hatching from another CAD station. Now, when I hatch and match the
scale factor; the hatches do not match on the screen. Is there a system
variable that controls this? Any help is much appreciated.
*Support], Keith Sibbert [Autodesk
Message 2 of 3 (53 Views)

Re: hatch scale

01-18-2000 10:27 PM in reply to: *Bleckley, John
Are you using the exact same hatch pattern? If you run the Audit command, does
it detect any errors? If you insert the drawing as a block into a new, start
from scratch drawing using the DDINSERT command, does it correct this?

--
Keith Sibbert
PSG Product Support, Americas
WW Support & Services, Autodesk
Discussion Q&A: http://www.autodesk.com/discussion

John Bleckley wrote:

> I am trying to hatch in a previously created drawing. It was created and
> includes hatching from another CAD station. Now, when I hatch and match the
> scale factor; the hatches do not match on the screen. Is there a system
> variable that controls this? Any help is much appreciated.
*Support], Ian Fenton [Autodesk
Message 3 of 3 (53 Views)

Re: hatch scale

01-19-2000 02:10 AM in reply to: *Bleckley, John
Check the MEASUREMENT system variable. Refer to the help for more info
on this.

--
Ian Fenton
Product Support, EMEA
WW Support & Services, Autodesk
Discussion Q&A: http://www.autodesk.com/discussion
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.