AutoCAD LT General Discussion

AutoCAD LT General Discussion

Reply
Valued Contributor
c.dufrene
Posts: 51
Registered: ‎04-26-2012
Message 1 of 2 (1,713 Views)
Accepted Solution

Enhanced attribute editor by defaut, how to change it ?

1713 Views, 1 Replies
10-11-2012 05:53 AM
Hi, By defaut a double click on a attribute opens the "enhanced" fonction. I don't want this, I want the "normal" attribute editor, is there a variable to change ? Or another way ? Thanks.

Do you mean you want DDEDIT command instead of BATTMAN command?

 

CUI command's pop-up stores all the double-click actions: change the default under ATTRIBUTE BLOCK and ATTRIBUTE DYNAMIC BLOCK from EATTEDIT command to DDEDIT command. You do this by deleting the definition at each location and replacing it from the list below.

 

Just be aware of what you are giving up in the process as far as features go.

*Expert Elite*
pendean
Posts: 23,004
Registered: ‎11-06-2003
Message 2 of 2 (1,701 Views)

Re: Enhanced attribute editor by defaut, how to change it ?

10-11-2012 09:46 AM in reply to: c.dufrene

Do you mean you want DDEDIT command instead of BATTMAN command?

 

CUI command's pop-up stores all the double-click actions: change the default under ATTRIBUTE BLOCK and ATTRIBUTE DYNAMIC BLOCK from EATTEDIT command to DDEDIT command. You do this by deleting the definition at each location and replacing it from the list below.

 

Just be aware of what you are giving up in the process as far as features go.

Dean Saadallah Blog | Facebook | Google+ | Twitter | PINS
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.