It's the strangest thing. I'll draw a 6' long line, go to measure it and it comes up as 5-'6-1/2".
Units are set to architectural at 1/16" precision
Measureinit is set at 0
The drawing is copied from another file which I did not create.
Any ideas??? I would appreciate any help.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!