Dim Associate Warning LT2013

[Chisel]

I have started getting warnings (exclamation mark) on 1 particular drawing warning that some dimensions and leaders are dis-associated. How do I turn this feature OFF??

Sometimes I don't want a leader arrow to actually touch a line. So getting the warning on lots of dims is very distracting.

[pendean · Accepted solution]

Look up ANNOMONITOR in Help.

[Chisel]

That's fixed it thanks. Part of the trick is to know what to look for.

[pendean]

I found it by looking up DIMASSOC (what you had turned on), then clicked on the link at the bottom that expanded on procedures, then at the bottom if that list there is always a full list of all commands and variables that are related to the DIMASSOC setting.

Sounds complicated but it's not after you do it more than once: you'll find almost all commands and variables can be found the same way. Just start with the command you are in or have a question about.