Surface Lisp

[kbellson]

how can i set a varible (setq XX)
to be the elelvation of a selected spot of the current surface
basically the same as the inquiry command but
a one time selection and save the elevation to a varible.

so i can enter it into a block Message was edited by: kbellson

[Anonymous]

Hey kbellson;

There are those who can probably answer that query, but did you also know
about this portion of the LDT DG?
http://tinyurl.com/jrzpn

HTH

--
Don Reichle
"The only thing worse
than training your staff,
and having them leave is -
not training your staff,
and having them stay."
Courtesy Graphics Solution Providers
----------------------------------------------------------
C3D/LDT/CD/SVY-2K6
Intel P4-3.00GHz
XPPro 32bit SP2
1GB RAM
Nvidia GeForce2 Ti 64MB


wrote in message news:5101610@discussion.autodesk.com...
how can i set a varible (setq XX)
to be the elelvation of a selected spot of the current surface
basically the same as the inquiry command but
a one time selection and save the elevation to a varible.

so i can enter it into a block

Message was edited by: kbellson

[kbellson]

no i did not look at all the catagories.
thanks, i will repost my question in the correct forum.