I try to create station labels beginning at 0+00.00 to lets say 25+65.35 and it works fine but when I try to do from 0+00.00 to -8+65.00 it will only label last station and increment is set to 100
Why are you using negitive stationing?
I always try to start my alignments with a reference point that will allow no negative stations - in the example you gave, my reference point would be 10+00.00. I usually build by alinments with a beggining section that runs 25 to 50 feet before my reference station (0+75.00 & reference @ 1+00.00).
If your alignment design changes that much that you need to add a couple hundred feet (meters) of negitive stations, I'd create a new alignment and profile.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!