Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am getting the following error when processing sections. I have set my surface and followed all the required steps that are documented.....wasn't sure if someone else ran across this and had any suggestions. For some reason it mentions a TXT file for the surface:
Calculating the elevations from the surface. Please wait.
Error - Unable to open file , for
reading.Error - No surfaces defined.
ERROR - Generating cross section file
You have toggled on "Multiple Surfaces" and the .txt file stores the
list of surfaces to be used. Hit the toggle again and make sure it reads
"Multiple Surfaces Off". Then resample.....
--
Karl Fuls PLS
Autocad AEC Training and Consulting
Autodesk Discussion Group Facilitator
NomarFlutie wrote:
> Hello,
>
> I am getting the following error when processing sections. I have set my surface and followed all the required steps that are documented.....wasn't sure if someone else ran across this and had any suggestions. For some reason it mentions a TXT file for the surface:
>
> Calculating the elevations from the surface. Please wait.
> Error - Unable to open file , for
> reading.Error - No surfaces defined.
> ERROR - Generating cross section file
>
> Thanks for your help!
>
> Dennis Pelletier
