I am using two different pipe sizes in my design (8" and 15"). I setup one pipe size for the 8" pipe and the changes I make for the 15" pipe shows up in the 8" pipe dfm file. I make the changes back to the 8" pipe and then the 15" shows the same as the 15" pipe. I used to do this all the time and for some reason the two different dfm's are over writing each other. I always import and export the dfm before working with the other. Am I missing a step somewhere in defining these two dfm's? I am using LDD 2006.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!