AutoCAD Land Desktop

AutoCAD Land Desktop

New Member
Posts: 1
Registered: ‎03-14-2003
Message 1 of 3 (808 Views)

Cut Fill calculations in meters?

808 Views, 2 Replies
05-19-2009 08:52 AM
LD 2006, performing volume calculations. I read on a separate post that calculations are given in "cubic yards" - does the program run a calculation assuming the contours are in feet?

The units in our drawing are set to decimal. The volumes seem low - I was wondering if we were to backtrack and cube the "cubic yard" calculation if that would really be the cubic meter calculation? It would make sense if the program is running an automatic "feet to yards" calculation.....
Posts: 21
Registered: ‎12-12-2006
Message 2 of 3 (808 Views)

Re: Cut Fill calculations in meters?

05-21-2009 04:53 AM in reply to: hayleyannp
What is your drawing setup for? If you go to the Project menu and select 'Drawing Setup' then select the tab 'Units' is it set for feet or meters?
New Member
Posts: 1
Registered: ‎06-27-2013
Message 3 of 3 (623 Views)

autodesk 2014 populate

06-27-2013 06:15 AM in reply to: K_Woodruff

the autodesk 2014 populate not working in meters so i want some ideas to work for populate with mesurements of meters.

can anybody help me?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.