Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have a alignment created along the centerline of a stream. I have created a profile and cross sections. The cross sections are sampled for 2000' left and right of centerline. I need to have points placed every 50' along these sample lines. Is there a way to create these points from the cross sections. I also need to create an ascii file from the points.
If that is the width - transition alignments are outof the question. But if
you create a cl poly line with verts every station then offset 50 feet l&R
for 2000ft you can then place points auto at the verts & extract the ground
ele via stratums.
thats one way - I' quite sure there are many other ways too.
Joe
wrote in message news:5440387@discussion.autodesk.com...
I have a alignment created along the centerline of a stream. I have created
a profile and cross sections. The cross sections are sampled for 2000' left
and right of centerline. I need to have points placed every 50' along these
sample lines. Is there a way to create these points from the cross
sections. I also need to create an ascii file from the points.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")