AutoCAD Land Desktop

AutoCAD Land Desktop

Reply
New Member
dkeon
Posts: 1
Registered: ‎12-13-2012
Message 1 of 2 (923 Views)

Cant't open drawing from the command line

923 Views, 1 Replies
12-13-2012 12:51 PM

I am trying to open a drawing from the command line,

i have FILEDIA = 0, CMDDIA = 0.  after typing OPEN or

using OPEN in a script the dialog box opens using AECOPEN.

SAVE works fine this way, but not open. 

I have run out of ideas on how to open a file without that dialog box

popping up.

 

Thanks for any help.

*Expert Elite*
Jeff_M
Posts: 4,450
Registered: ‎07-22-2003
Message 2 of 2 (920 Views)

Re: Cant't open drawing from the command line

12-13-2012 03:18 PM in reply to: dkeon

Make sure the LayerManager palette is closed, and possibly also the Properties palette, otherwise you will likely get into a circular Unhandled Exception issue and need to end the task in Task manager.

 

Use the ".OPEN" command. Note the period preceding OPEN....this tells it to use the Origianl command, not the one used to redefine it by LDT.

Jeff_M, also a frequent Swamper
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.