I have an aerial in state plane coordinates that I Im trying to insert to my drawing. The drawing has a base 00,00
I have done this before, and it works as long as I bring he Aerial in map/insert /image and so on.... , but I am missing something because the aerial does show up in the place where the dwg is.
Or I should say my drawing is not where it supposed to be. What am I missing??
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!