AutoCAD for Mac General Discussion

AutoCAD for Mac General Discussion

Reply
Valued Contributor
JohnRennie
Posts: 93
Registered: ‎02-07-2011
Message 1 of 1 (68 Views)

Publishing issue

68 Views, 0 Replies
04-23-2012 05:53 PM

I'm noticing some issues when publishing multiple drawings where the pagesetup does not always work properly. On some dwg files it works fine and my drawing is centred perfectly on a page but others it has been slightly offset (by about 5-10mm).

I've tried deleting the pagesetup and importing from a drawing file that works, but I still get the same result.

 

It only happens when publishing and will work fine if I plot a single sheet to PDF in the normal fashion.

 

This is all when printing to an A1 size.

 

Has anyone else noticed anything like this?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.