Annoying simbols

[Anonymous]

Hello everyone,

I have this annoying symbols in some of my lines when the selection tool is near... (image). Don't know what did i do to activate them. Not sure if the flatten command is what i need, but the Autocad for Mac doesn't recognize it... What should i do?

Please help!!,

Mel

[maxim_k · Accepted solution]

Hi Mel,

These are parametric constraints symbols. To remove them you need to go to menu Parametric -> Delete Constraints, than when AutoCAD will ask to select objects, type ALL at the command prompt and hit Return two times:


After you will delete all constraints, please verify also if you have Infer Constraints enabled on the Status Bar (if you have full AutoCAD version - LT doesn't have Infer Constraints toggle, because you cannot create constraints in LT).

Look also here:
http://forums.autodesk.com/t5/autocad-for-mac-general/can-t-seem-to-move-only-one-object/td-p/605376...

Maxim

[Anonymous]

Thank you Maxim!!

Mel