AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Active Contributor
priva2
Posts: 41
Registered: ‎02-02-2010
Message 1 of 2 (70 Views)

Xref issuse source destination arrows

70 Views, 1 Replies
05-07-2012 11:50 AM

I am trying to get our source/destination arrows to show drawing-rung number.(%D-%N).  It seems to keep doing %D-%S.  Under the project properties for same drawing and between drawings I have %D-%N but it is still coming up %D-%S.  Is there somehwere else I should be looking?

Active Contributor
priva2
Posts: 41
Registered: ‎02-02-2010
Message 2 of 2 (54 Views)

Re: Xref issuse source destination arrows

05-08-2012 12:45 PM in reply to: priva2

So I was able to find out an answer.  I had changed the xref setting for the project but xref settings can also be drawing specific.  The existing pages in the project had different xref settings.  We will need ot make a template project with all the drawings set properly as well as all the drawings.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.