Wire Sequencing

[Anonymous]

When i go into manual pick on my sequencing on my projects with more than 1 terminal in the sequence the terminal shows 3 wires being connected to the terminal even though i have picked them and it shows a different order with the green arrow (Show wire sequence).
I have by chance tried this on another version of ACAD E and seems to work with all settings saved locally but our settings our all saved on cadshare could this be affecting the wire sequencing/terminal strip editor in some way ?

[dougmcalexander]

Hmm...I will need to see an example of this. The wire sequencing has always
worked flawlessly for me.

wrote in message news:5820225@discussion.autodesk.com...
When i go into manual pick on my sequencing on my projects with more than 1
terminal in the sequence the terminal shows 3 wires being connected to the
terminal even though i have picked them and it shows a different order with
the green arrow (Show wire sequence).
I have by chance tried this on another version of ACAD E and seems to work
with all settings saved locally but our settings our all saved on cadshare
could this be affecting the wire sequencing/terminal strip editor in some
way ?

[Anonymous]

This is actually a problem in the TSE. I have set sequences on the
schematic, Run the TSE and inserted the terminal strip and found problems.
The only workaround I have found that works is to redo all sequences, Do a
full project update, then run the TSE.

Pat (from autodesk) found that the TSE was filling in some information it
shouldn't on the terminal schematics. This was causing the Direct To
Terminal problems.

Regards Brad

wrote in message news:5909417@discussion.autodesk.com...
Hmm...I will need to see an example of this. The wire sequencing has always
worked flawlessly for me.

wrote in message news:5820225@discussion.autodesk.com...
When i go into manual pick on my sequencing on my projects with more than 1
terminal in the sequence the terminal shows 3 wires being connected to the
terminal even though i have picked them and it shows a different order with
the green arrow (Show wire sequence).
I have by chance tried this on another version of ACAD E and seems to work
with all settings saved locally but our settings our all saved on cadshare
could this be affecting the wire sequencing/terminal strip editor in some
way ?