I can't seem to have line reference wire numbers on my ladder. I set it in the project settings to 1,2,3 but the numbers remain the same as the first line number. Any suggestions ?
I'm not sure if this is the issue or not, but the wire number doesn't change through node dots. It will change once you insert symbols onto a rung but it will only change on the side of the symbol that is opposite the ladder rail (bus). See attached screen capture. I'm just guessing since I haven't seen your drawing, but this can sometimes be confusing for new users of ACE. The line reference-based wire numbers can only start if the is a component separating the rung from the rail (bus).
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.