AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Contributor
mikegoutier
Posts: 15
Registered: ‎05-20-2012
Message 1 of 2 (143 Views)

wire numbers from inline to ontop of line

143 Views, 1 Replies
10-01-2012 12:49 PM

I am using an old drawing schematic that used inline wire numbers and our new SOP states we need to use ontop of wire wire numbers. I have changed the project (wdp) settings to ontop and updated to the project defauts on the drawing level. Than is i use the command AEIWRENO it wont change them from inline to ontop.

any ideas?

Contributor
mikegoutier
Posts: 15
Registered: ‎05-20-2012
Message 2 of 2 (137 Views)

Re: wire numbers from inline to ontop of line

10-01-2012 01:21 PM in reply to: mikegoutier

part 2 of this question is then i want my wire color and gauge to be below the wire in the center under the wire number by using the command aewirecolorlabel it doesnt seem to allow me to have that control.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.