Does anyone knows how I can change the height and width factor for a line reference? I tried the environmental file but no luck. How does ACE knows where to pick from the library?
Also, is there a link somewhere on how to use spreadsheet to build a symbol?
Thanks for all the help.
I haven't receive any guide on the above question. Excuse me if it is an easy question; I will appreciate any link or help on how to understand this two workflow.
Thanks for reading...
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!