AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

New Member
2 Posts
0 Kudos
Registered: ‎12-03-2012
Post 1 of 2

UNDO command went crazy

214 Views, 1 Replies
12-04-2012 04:01 AM

I’ve been using AutoCAD Electrical for some months without problems.


Last week my UNDO command went crazy

Each time I open a file, it is turned off or disabled.


I type undo in the command line and I receive the actual settings

“Current settings: Auto = Off, Control = None, Combine = Yes, Layer = Yes

Enter an undo control option [All/none/One/Combine/Layer] <All>:”


I press enter key, and type undo again, the settings were changed

Current settings: Auto = On, Control = All, Combine = Yes, Layer = Yes

Now every thing it’s OK.


I have tried FILEDIA and UNDOCTL, without success.

Probably it’s very easy, but I do not know how to fix it.




Valued Contributor
79 Posts
2 Kudos
Registered: ‎08-23-2007
Post 2 of 2

Re: UNDO command went crazy

12-10-2012 11:30 AM in reply to: pmbernardo

I kow how you feel. I'm going through the same thing, see my post


And appearently this has been an acade bug for a long time.



Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.