This note came in outside of the discussion group and is reprinted here with
originator's permission. It might be of general interest.
QUESTION: I have been attempting to use the fan-in/out (source/destination
signal pairs) for something but it places one piece of wire
on the MULTI-WIRE layer and I lose wire info when I have a PJ block
attached.
RESPONSE: I think a better approach is to make the "gap" between the plug
and jack connections look like a big "gap" without the "loop". This
preserves the wire number from the end of one wire to the beg of the next
without having to resort to source/destination symbols. On the bottom part
of your sample drawing, use the Check/Repair Wire Gap command. Pick pairs of
wire segments. The wire numbers will cross the gap and I think that
everything will still work as you want.