AutoCAD Electrical Forum
Welcome to Autodesk’s AutoCAD Electrical Forums. Share your knowledge, ask questions, and explore popular AutoCAD Electrical topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Terminal Strip editor

2 REPLIES 2
Reply
Message 1 of 3
atlimar1
378 Views, 2 Replies

Terminal Strip editor

Does it matter how i connect the terminal, internal or external?  I am having problem to make a terminalplan with the correct desitnation, I have tried to changed the desitnation in Terminal Strip Editor, but it makes no different. Shall I do any thing else?

2 REPLIES 2
Message 2 of 3
Icemanau
in reply to: atlimar1

Setting the Internal and External connections of the terminal will allow the TSE to have the correct wire connections from the start, rather than changing them one by one when doing the layout. I usually do this just before I do the layout as I can just go through and do all the terminals at once on the one runthrough of the command rather than insert the terminal, exit, set internal/external, insert terminal and so on.

 

It also pays to do a full rebuild of the project first before doing so, set the internal/external connections and then also setting any special wiring sequences before doing the TSE.

 

Regards Brad



Icemanau (NNTP handle: Brad Coleman
AutoCAD Electrical User and IT Hardware Support

Message 3 of 3
Justin2012
in reply to: Icemanau

I too have a concern about that too. Below(also refer to the attachment if it is not clear) are two wire connections and their appropriate terminal strip representation. I think it is wrong but need another clarification. Please...thx

 

Capture2.JPG

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost