AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Active Contributor HAZ
Active Contributor
26 Posts
0 Kudos
Registered: ‎03-16-2009
Post 1 of 2

Suppress Wire Collision Check ON/OFF

162 Views, 1 Replies
04-18-2010 11:06 PM
Hi
Is it possible to set "Suppress Wire Collision Check" ON/OFF in the same session without leaving the Autocad Electrical 2011?
Regards Hamid Z
HAZ
*Expert Elite*
1,053 Posts
150 Kudos
Registered: ‎09-21-2007
Post 2 of 2

Re: Suppress Wire Collision Check ON/OFF

04-19-2010 08:37 AM in reply to: HAZ
Hi Hamid.

I'm not quite sure what you mean here. The Suppress Wire Collision Check IS set within the current session, inside the Insert Wire command. If you Exit AcadE, it's turned on again.

If you want it to always be default off, you could always add this line to WD.ENV:
SETQ:GBL_wd_skip_collision_check,'1

THL

Trond Hasse Lie

ECAD Consultant, CtrlAltEl

Please select "Accept As Solution" if this post answers your question. Kudos don't hurt either. ;-)
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.