AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Active Member
6 Posts
0 Kudos
Registered: ‎12-18-2012
Post 1 of 2

Source arrows retagging

191 Views, 1 Replies
12-21-2012 10:13 AM

Is there a way to update by retagging all your source arrow and destination arrows at one time through out the project.  I know you can go one by one and right clicking on them and click retag which updates the sheet number and the reference number.  Just want to know if there is a way to update them all through out the hole project.

*Expert Elite*
1,106 Posts
76 Kudos
Registered: ‎03-09-2004
Post 2 of 2

Re: Source arrows retagging

12-21-2012 11:57 AM in reply to: mtennie

On the Schematics tab, under Edit Wires/Wire Numbers Pulldown, you will find Update Signal References (4 from the left). This will open a a dialog box that will allow you to make project wide Source/Destination arrow updates.

Bob Hanrahan
Ace User since 1998
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.