AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Active Member
TCWestern
Posts: 9
Registered: ‎06-14-2011
Message 1 of 4 (303 Views)

Source and Destination Arrow Scaling

303 Views, 3 Replies
06-14-2011 09:20 AM

When I enter source or destination arrows on a certain drawing, the arrows and text are scaled very large. I reviewed the similar posts on this forum but none of them helped. In the Drawing Properties, Drawing Format Tab the "Feature Scale Multiplier" is set to .75  (inch). I opened up the symbol file "HA1S1" in the JIC1 library (and JIC125) and it appears to be scaled at a reasonable size. What else can I check to get rid of this annoyance? Thanks in advance for your responses.

*Expert Elite*
dougmcalexander
Posts: 3,166
Registered: ‎10-18-2003
Message 2 of 4 (296 Views)

Re: Source and Destination Arrow Scaling

06-14-2011 12:04 PM in reply to: TCWestern

I assume you checked to be sure your project properties are set to either the JIC1 or JIC125 library path.  Can you post a screen shot of just how much too big they are?  Like if they are 25.4 times too big it indicates to me that they are coming from the IEC2 or IEC4 library.

Doug McAlexander
Independent Consultant/Instructor/Mentor specializing in AutoCAD Electrical, ecscad, and promis-e implementation

Web site: www.ECADConsultant.com
Phone: (770) 841-8009

Please Accept as Solution if I helped you. Kudos are also much appreciated.
New Member
IdahoPHANTOM
Posts: 1
Registered: ‎06-22-2011
Message 3 of 4 (262 Views)

Re: Source and Destination Arrow Scaling

06-22-2011 11:35 AM in reply to: TCWestern

I have the same problem. It started after I made a block in symbol Builder. It does not do it in any other DWGs except that one.

 

Cole Bode

Design Engineer 

Active Member
TCWestern
Posts: 9
Registered: ‎06-14-2011
Message 4 of 4 (243 Views)

Re: Source and Destination Arrow Scaling

06-24-2011 01:33 PM in reply to: dougmcalexander

I got side tracked on some other stuff and the file got over written by another person. But the scaling was huge, like it was as big as my whole sheet. It was in a project where other sheets were fine. I compared settings between sheets and they seemed to be the same too.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.