When using the Spreadsheet to PLC I/O Utility, I am unsuccessfully attempting to place source and destination arrows. I am attempoting to place a source arrow and a destination arrow on the same line. I can do this manually on the drawing with no problem. However, when IU attempt to place a source and destination arrow on the same address line, using the spreadsheet, either the source or the destination wire connection drops out.
What can I do to add souce and destination arrows via the PLC spreadsheet
The drawing you sent out was blank.
Could you resend it so I can take a look at it?
Try these in the DxBLK field:
"HA1D3" - Destination arrow for input cards
"HA1S1" - Source arrow for output cards
You may also add the signal code in DxTAG fields to save time. Be sure to use a unique signal code for each arrow.
Don't forget to try RackLayout.com when creating the Excel sheet.
Sorry...I failed to attach the sample file properly.
Hopefully, it willbe attached, here.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.