I am very new to AutoCAD Electrical and I'm having trouble adding additional contacts to componts, namely selector switches. How is that process done? When I add a selctor switch it only adds a single contact.
AutoCAD Electrical 2013
Thank you in advance.
Go back to the Selector Switch category in the menu and click on the 2nd+ contact of your choice, either NO or NC. Insert the contact next to the parent contact that you already inserted. Click Parent/Sibling to associate this additional contact to the existing contact. The reason Electrical works this way is so that you are not limited to a certain wire spacing. You can insert multi-wire components across any group of wires no matter their spacing. Hint: This same method can be used for pushbuttons, relays, and any other switching device that can have 2 or more contacts.
If a selector switch has 4 contacts, how would you go about distinguishing between the different contacts?
Currently I assign pin # to each contact to distinguish it from other contacts but I'm not sure if it is the right thing to do. For example, contact #1 would have pin # 1 and 2. Contact #2 would have pin # 3 and 4.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!