I'm doing JIC ladder drawings. In the drawing properties I have sheet set to "01", Section set to "D", Sub section set to "C" and Drawing is set to nothing. Under component and wiring tagging I have the following set
Component - %F-%A%B%S%N
Wire number format - %A%B%S%N
Components tagging is fine eg. PB-DC0113A
However the wire numbering ignore the %A & %B
eg. 0104A is all I get for a wire tag
If I set the value for drawing under drawing properties to "FU" and I leave the wire format as it was
Wire number format - %A%B%S%N
the wire numbers show the drawing value added (even though it shouldn't)
eg. FU0104A is the tag for a wire
components remain unaffected eg. PB-DC0113A
I could set the drawing value to a combination of sec and subsec but thats extra steps.