I added an attribute to the parent cable marker for screened cable. Not a problem I've done this on many symbols, however when I updated the symbol project wide, it moved all the parent markers out of line with the child markers? (see attached pic). As my project is very large with over a hundred cables in it, having to go through every drawing aligning them back up again is very annoying. Can anyone shed any light on why it does this? I haven't changed anything of the graphics in the symbol just added an attribute?
That is strange. I do know that if you have a grip active (i.e., snap to endpoint) it can cause problems. Was something like that active??
Nope, I checked that, I've been using AutoCAD and ACADE for many years and it didn't do this on earlier versions, or not that I was aware of. I'm using ACADE 2011, and it's up to date.
Can you take a look at where the insertion point of the original block is, using the INSERTION osnap?
Just to check if it is AcadE's update function that creates this error, or if the error was there already?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.