AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Distinguished Contributor
Posts: 151
Registered: ‎12-11-2003
Message 1 of 2 (87 Views)

Revisions to drawings

87 Views, 1 Replies
04-07-2004 06:10 AM
How do you handle revisions to drawings in ACADE?
Before ACADE we would put a revision only on the sheet that changed, not on the whole project. There seems to be no way to just have a revision show up on one sheet of a multisheet job with ACADE.
Also how do you handle saving the old file when you create a revision, if you leave it in the project and mark it "reference", it still numbers the sheet. This causes a 2 sheet project with a revision to reflect it is a 3 sheet project
*Expert Elite*
Posts: 1,093
Registered: ‎03-09-2004
Message 2 of 2 (87 Views)

Re: Revisions to drawings

04-07-2004 08:31 AM in reply to: fdna49
You can provide a seperate field to add a revision independent to the AE Titleblock (Like MText). When updating TBs, do not select resequence sheets and this will not happen.
Bob Hanrahan
Ace User since 1998
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.