AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Active Member
6 Posts
0 Kudos
Registered: ‎09-27-2004
Post 1 of 2

multiple item numbers on a single detail

122 Views, 1 Replies
11-03-2004 08:55 AM
If I wanted to show the main fuse from the disconnect, I would show in the bom the fuse, the fuseblock etc., How do you show multiple item no. to a single detail on the backplate layout. Do you have to copy multiple blocks and assign each item number or is there a way through the multiple catalog when inserting the fuses, to assign multiple item numbers?
Don't want to make the drawing size larger than needed.
New Member
1 Posts
0 Kudos
Registered: ‎01-08-2013
Post 2 of 2

Re: multiple item numbers on a single detail

01-08-2013 08:30 AM in reply to: emarion

I would also like to know if I can somehow use the fuse part number from the catalog on multiple slots in the fuse holder footprint. I.E. we use a lot if 3 phase fuse holders and when we put the footprint in we need the fuse part number to show on all 3 phases.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.