I have an Omron RFID unit that uses a 50pin Honda connector for digital i/o.
I have not come up with a good way of drawing this type of device in AcadE
yet.
I would like people to post ideas of how they have done similar schematics
or how they think they would do it so I can get some other ideas to make the
drawings flow better.
Currently, I only draw the power going to the Omron RFID controller. Then,
on my plc page, I have the input coming from line and page number that the
RFID controller is wired on, and same for the outputs. This works, but does
not use any of the "power" included in AcadE.
Please let me know your ways or suggestions for doing this.
Thank you,
Keith