AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
*krollenhagen
Message 1 of 2 (182 Views)

multi-conductor cable & device wiring

182 Views, 1 Replies
12-01-2003 06:16 AM
I have an Omron RFID unit that uses a 50pin Honda connector for digital i/o.
I have not come up with a good way of drawing this type of device in AcadE
yet.

I would like people to post ideas of how they have done similar schematics
or how they think they would do it so I can get some other ideas to make the
drawings flow better.

Currently, I only draw the power going to the Omron RFID controller. Then,
on my plc page, I have the input coming from line and page number that the
RFID controller is wired on, and same for the outputs. This works, but does
not use any of the "power" included in AcadE.

Please let me know your ways or suggestions for doing this.

Thank you,

Keith
Valued Contributor
Lint
Posts: 56
Registered: ‎12-04-2003
Message 2 of 2 (182 Views)

Re: multi-conductor cable & device wiring

12-02-2003 10:26 PM in reply to: *krollenhagen
I have similar problems trying to handle cables
on my drawings. We are using rung/sheet to number
our components & wires. I either "fake" the cable
run by either creating a wire on a CABLE layer
(if my drawing never shows the cable conductors)
or I use a stand-alone cross reference, probably
similar to what you do to show the where the
cable is coming from on the plc pages.
I would love a better way of doing this. I don't
think my way is going to be able to generate
a good cable to from for the wiring people.
Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.