Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Is there a reason the location box defaults
to the current layer?
I have reset it in the config to a LOCBOX
layer, but it keeps defaulting to CURRENT and then
changing the line type/color of that layer.
Lynne
In some other case I have seen
similar to this, the drawings have ended up with multiple wd_m blocks on
them. Also, make sure that the layer you are typing in actually
exists.
-- Sincerely,
Jared Bunch Technical Support Specialist Autodesk, Inc
Is
there a reason the location box defaults to the current layer? I have
reset it in the config to a LOCBOX layer, but it keeps defaulting to
CURRENT and then changing the line type/color of that layer.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")
