AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Member
n.a.smith
Posts: 4
Registered: ‎11-09-2011
Message 1 of 2 (139 Views)

Line Reference wire/component numbers wrong

139 Views, 1 Replies
04-27-2012 04:57 PM

For some reason when I insert a component using line reference numbering, it uses the next reference line number. 

 

Example:

I have a single phase ladder with 25 rungs and reference lines start at 101.

I insert a coil on reference line 101 and it numbers the component as CR102. Then numbers the wire as 102.

What happpened?

How do I correct this? 

*Expert Elite*
dougmcalexander
Posts: 3,204
Registered: ‎10-18-2003
Message 2 of 2 (130 Views)

Re: Line Reference wire/component numbers wrong

04-30-2012 06:50 AM in reply to: n.a.smith

Not seeing your drawing, it is hard for me to say, but if you are more than halfway between line references, the tags and wire numbers use the next line reference number.

 

Another consideration is the Feature Scale Multiplier.  If you have it set to a very high number, it can cause all sorts of problems with referencing.  It should not be used for scaling between Metric and English units.  I suggest no value higher than 2 or less than 0.5.  Use it to double the size of symbols or to half them.  That is the best use of the FSM.  If you need Metric to English conversion, use the Modify Symbol Library utility.

Doug McAlexander
Independent Consultant/Instructor/Mentor specializing in AutoCAD Electrical, ecscad, and promis-e implementation

Web site: www.ECADConsultant.com
Phone: (770) 841-8009

Please Accept as Solution if I helped you. Kudos are also much appreciated.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.