AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Posts: 4
Registered: ‎09-08-2010
Message 1 of 2 (221 Views)

Item catalog change

221 Views, 1 Replies
09-14-2010 04:07 AM



I made a drawing set with certain type of control relays.  Now I have information about the relays that were used in the project and the pin numbers on them are not the same as I put on the drawings.  Is it possible to change the catalog information all in one run and update the pin numbers at the same time?


With best regards


Distinguished Contributor
Posts: 302
Registered: ‎02-21-2009
Message 2 of 2 (57 Views)

Re: Item catalog change

03-20-2012 07:09 AM in reply to: Thorolfur

Hi, use Component update from Catalog placed under the project tab.

Hope this helps.

Regards, Gary

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.