AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Valued Contributor
keithjk
Posts: 100
Registered: ‎07-23-2008
Message 1 of 2 (385 Views)

Inventor Cable and Harness and AutoCAD Electrical Question

385 Views, 1 Replies
06-25-2013 07:21 AM

I have worked through a tutorial using Inventor Cable and Harness with AutoCAD Electrical and it does seem to work slick.  I also created a small project from scratch without an issues.

 

Currently, we do all of our panel layout design work (within AutoCAD Electrical) in 2D.  To use Inventor Cable and Harness, wouldn't we need to convert to 3D?  And since we use a lot of the Electrical commands (schematic to panel, etc), would we have to lay the panel out in AutoCAD Electrical, and then finish up the cable and harness in Inventor?

 

Thanks,

Keith

Valued Contributor
rwydesk500
Posts: 54
Registered: ‎01-13-2010
Message 2 of 2 (308 Views)

Re: Inventor Cable and Harness and AutoCAD Electrical Question

07-18-2013 10:04 AM in reply to: keithjk

Sounds like you are going to want to check this out Autodesk University. I hope the link works ok for you.

Regards,

Rick Yoerger

AutoCAD Electrical 2014
Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.