AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Active Contributor
hkim
Posts: 36
Registered: ‎02-05-2004
Message 1 of 2 (60 Views)

Insert Component Wiring List

60 Views, 1 Replies
03-19-2004 12:37 PM
The insert component wiring list command (Schem wirenums to AutoCAD Electrical layout) does not reset the ATTREQ system variable. The command changes the variable to a value of "0" which will insert blocks with the defaults for the values of all attributes (not allowing the user to enter the values of the block's attributes during insertion.

Regards,
Hyun Kim
Powell Electrical Mfg. Co.
*Nate Holt \(Autodesk\)
Message 2 of 2 (60 Views)

Re: Insert Component Wiring List

03-19-2004 01:50 PM in reply to: hkim
Hyun, You're absolutely right. I'll log this in the defect queue. Nate. "hkim" wrote in message news:5785611.1079728696042.JavaMail.jive@jiveforum2.autodesk.com... > The insert component wiring list command (Schem wirenums to AutoCAD Electrical layout) does not reset the ATTREQ system variable. The command changes the variable to a value of "0" which will insert blocks with the defaults for the values of all attributes (not allowing the user to enter the values of the block's attributes during insertion. > > Regards, > Hyun Kim > Powell Electrical Mfg. Co.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.