AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
New Member
bruen
Posts: 2
Registered: ‎03-29-2004
Message 1 of 2 (51 Views)

i/o via spreadsheet problem or bug

51 Views, 1 Replies
04-02-2004 05:11 AM
The program seems to be missing the ability to do sheet # and line # without hex block. For example I want the sheet num to be 20 and line num to start with 01. When I running program the line num goes in just fine but sheet num does not go in at all. There is a pop up that comes up when run this spreadsheet to i/o drawing does not give you the choice for sheet num / line num unlike the project configuration and drawing config/defaults which are both set for %S%N.
Valued Contributor
dlshood
Posts: 78
Registered: ‎02-10-2004
Message 2 of 2 (51 Views)

Re: i/o via spreadsheet problem or bug

04-27-2004 02:18 PM in reply to: bruen
You need to enter the starting sheet number when running the Spread sheet i/o program.
Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.