AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Distinguished Contributor
fdna49
Posts: 151
Registered: ‎12-11-2003
Message 1 of 2 (71 Views)

Global attribute switch

71 Views, 1 Replies
04-13-2004 11:47 AM
Is there a way to turn on/off attributes globally?
I am adding locations to components on an existing schematic to easy creating panel layouts, and the "loc" attribute seems to be turned on for all components on the drawing.
I don't need the location to show on the electrical schematic.
*Jared Bunch \(Autodesk, Inc\)
Message 2 of 2 (71 Views)

Re: Global attribute switch

04-13-2004 12:33 PM in reply to: fdna49
You should be able to just do this by turning off the LOC layer. The LOC code attribute should be getting automatically placed on this layer, therefore turning it off should "hide" all of the LOC attributes in that drawing. Hope this helps!! -- Regards, Jared Bunch Technical Support Specialist Autodesk, Inc "fdna49" wrote in message news:21563245.1081882065033.JavaMail.jive@jiveforum2.autodesk.com... > Is there a way to turn on/off attributes globally? > I am adding locations to components on an existing schematic to easy creating panel layouts, and the "loc" attribute seems to be turned on for all components on the drawing. > I don't need the location to show on the electrical schematic.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.