AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
New Member
Marina.M
Posts: 2
Registered: ‎12-20-2012
Message 1 of 2 (234 Views)

Fix attributes at the same position

234 Views, 1 Replies
12-20-2012 07:24 AM

When I revert a block, the attributes reverse too. Is there any way to make those attributes be fixed at the same position independently if the block will be reverse or not?

 

Thanks,

 

Marina.

Active Contributor
kghew1
Posts: 34
Registered: ‎04-28-2011
Message 2 of 2 (227 Views)

Re: Fix attributes at the same position

12-20-2012 08:23 AM in reply to: Marina.M

Hi Marina

 

Have you tried checking 'Graphics only' in the Reverse / Flip Component dialogue ?

 

Note too that this function likes components with only a couple of terminals, but gets confused when there are lots of terminals, or opposed terminals that are not exactly in line with each other on opposite sides of the symbol.

 

I have also seen a quirk with some symbols where if you reverse them, then decide that you liked it better the first way, and try to re-reverse them back again - they simply vanish.

 

Hope this helps

Keith H

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.