AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Valued Contributor
Jay Mackey
Posts: 62
Registered: ‎06-21-2004
Message 1 of 2 (109 Views)

Error: bad xsubr(L) instruction (offs code): 37534 0

109 Views, 1 Replies
06-21-2004 07:00 PM
I'm semi-new to AutoCad Electrical, and I just started the Tutorial that has you start off by opening the DEMO04.dwg file and insert a couple of rungs and a relay.

When a new component is inserted on a wire, the ISERT/EDIT Component dialog is supposed to pop up, but I get this error in the command line instead:

Error: bad xsubr(L) instruction (offs code): 37534 0

I'm sure that this is due to some irregularity on my system or in the configuration. Any help would be appreciated.

Jay
Valued Contributor
Jay Mackey
Posts: 62
Registered: ‎06-21-2004
Message 2 of 2 (109 Views)

Re: Error: bad xsubr(L) instruction (offs code): 37534 0

06-23-2004 09:34 AM in reply to: Jay Mackey
This was fixed by a total OS re-installation on this system, and then ultimately getting rid of the RAID mirror on this computer, which appears to be the primary culprit. So far, the new AE installation on this system with RAID system removed seems to be working correctly.

This was probably an OS generated error message that was being copied and shown in the AE comand line, rather than an internal AE error.

Jay
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.