AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Active Member
palahnukb
Posts: 9
Registered: ‎02-10-2012
Message 1 of 2 (626 Views)

Drawing number cross references between projects.

626 Views, 1 Replies
11-27-2012 09:48 AM

Hello,

 

I am using AutoCAD Electrical 2013 and have a few projects that reference each other.  I've searched the forums and there was a suggestion to use subfolders to seperate them projects but still have them reference each other.  This is working, but the issue arises when I cross reference.  I have set the drawings up so that when they reference on the same sheet is it only [*%N] and when it is on a different sheet it would be [Δ%S%N].  But the two project each have similar drawing numbers, so if sheet BA of Project1 references sheet BA of Project2, there is no distinction between the sheet numbers.  I know I can use the drawing number parameter %D in the cross reference, but this would appear for all cross references.  

Is there a way for AutoCAD to distinguish between two different locations and if so then place the drawing number in the cross reference?  Is this information contained in the signal arrow so that when it sees a different drawing number between source and destination arrows it can include the drawing numbers?  Thank you.

Mentor
sonny3g
Posts: 180
Registered: ‎05-09-2006
Message 2 of 2 (580 Views)

Re: Drawing number cross references between projects.

11-30-2012 12:23 PM in reply to: palahnukb

You can add either %I or %L for an installation or location code.

 

Scott

Scott G. Sawdy
scott.sawdy@bluecoyotecad.com
Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.