AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Active Contributor
41 Posts
0 Kudos
Registered: ‎12-24-2012
Post 1 of 2

Customised Circuit by using Circuit Builder

332 Views, 1 Replies
01-17-2013 01:16 AM



I have created the circuit in .dwg format and saved it in \Autodesk\Acade 2013\Libs\jic125, but am not able to call customized circuit from circuit builder by using spread sheet (ACE_CIRCUIT_BUILDER.XLS). I have updated the spread sheet in sheet ACE_CIRCS in DWG_TAMPLATE column. Please help me solve this issue.

Distinguished Contributor
150 Posts
35 Kudos
Registered: ‎12-08-2008
Post 2 of 2

Re: Customised Circuit by using Circuit Builder

01-17-2013 08:41 AM in reply to: laki.anu87

What is the exact name of the block? Verify that the block name matches.

You could try inserting the block it into the drawing before running CB. That would make sure its not a path issue but a CB issue.

Stan Wile
IMAGINiT Technologies
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.