AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Valued Contributor
Posts: 93
Registered: ‎12-19-2011
Message 1 of 1 (81 Views)

Circuit Builder scale issue

81 Views, 0 Replies
08-01-2012 03:07 AM

Hi all


I have encountered a scaling issue with Circuit Builder in ACADE 2013.  I dont know if it might be a project setting or the symbols themselves.


I created a Horizonltal FVNR circuit, configured it then placed it in the drawing.  Once placed in the circuit I noticed that certain symbols are really small.  Siemens Sirius Combination Starter 3RA11 being one of them.


I have attached both the drawing and the project files.  Plese rename ACADE Training.dwg to ACADE Training.wdp 


Has anyone else had this issue?  Is there a way to fix this?  Or am I at fault here?

Kind Regards
Carl van Rooyen
Application Engineer

Gigabyte Q1542, Win 7 Pro 64Bit, i5 - 3230M, 8 GB Ram
Intel HD Graphics with Nvidia GeForce 640M / 2GB and Optimus
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.