AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Active Contributor
36 Posts
0 Kudos
Registered: ‎07-02-2008
Post 1 of 1

Border Swap

70 Views, 0 Replies
07-29-2011 05:47 AM

After reading the thread below, I worked through swapping out title blocks/borders.

However, when I choose 1 block at a time, browse to location, and check retain old block scale and swap block, the new one does not adopt the old scale. Am I missing something? The title block text also looses any edits that may have been done (i.e. reduced width). Any help would be greatly appreciated.


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.