AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Contributor
MReed
Posts: 21
Registered: ‎06-30-2004
Message 1 of 2 (52 Views)

BOM in 2005

52 Views, 1 Replies
11-22-2004 01:42 PM
I am trying to run a BOM report for several panels within the same project. The first panel runs well, but when I get to the second panel I get an "unhandled exception C0000005 Access Violation" error. any ideas on how I can create more than 1 BOM within a project.
I have already set up the different panels with different dwg #'s and location identifiers, etc.

Thanks
Distinguished Contributor
MartinLee
Posts: 435
Registered: ‎01-14-2004
Message 2 of 2 (52 Views)

Re: BOM in 2005

11-23-2004 02:07 PM in reply to: MReed
You have to create a separate SET file for each report that you want to run. You might have a PANEL1.SET, PANEL2.SET, PANEL3.SET, and so on. The my comapany wants the reports forces me to do the BOM manually, and at this time there are some issues where ACE doesn't "remember" some of the settings. Good Luck!
Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.