I was trying to find more informartion & examples of where this s used, can not find anything in the electronic help or her on the forum.
I'm using it to as a ref link betwen sheets to link a multicore cabel however the electrical audit is saying no connection
- which is correct since their is no connection
ha2dl_ref
Am I using the correct symbol? should I just ignore the report audit?
Steve
Well,
Assuming that you made the appropriate Fan in/Fan out ends on seperate drawings, they are just connected using standard Source/Destination codes.
Thanks,
all works well except:
the electrical audit sees a missing connection as thier is no electrical connection, is this normal?
Steve
I do not think the audit shouuld show you an error if this is done like described in the help. Here is a link to the ACE wiki on this subject. Did you follow these procedures when setting up your multi-conductor cable?
Hi
Yes exactly, the fan out works fine and is reliable, the audit is also correct, the solution is to add a terminal to the ref block
so the multicore has a terminal to connect to - as expected. - fair enough
problem gone
Thanks
Steve
Yeah, sometimes you have to "trick" the software to do what you want to do.
Can't find what you're looking for? Ask the community or share your knowledge.