AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
New Member
Jack Feyes
Posts: 1
Registered: ‎12-16-2003
Message 1 of 1 (76 Views)

Black Box Builder

76 Views, 0 Replies
12-16-2003 12:50 PM
I have created a component with the black box builder and put it on the component picker dialog with the icon menu wizard. The part has three terminals on the left, three terminals on the right and eight terminals across the bottom. The problem I'm having is when I insert this component on a three phase wire it rotates the block 90 degrees. Is there a special procedure to create components for three phase circuit insertion?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.